6143 - Laserfiche WebLink

Home Browse Search

Maintenance of Common Areas and Facilities 4. Specific Requirements: It shall be the responsibility of each responsible party. to accomplish the disclosure required by this section. Without limiting the generality of this obligation, the disclosure, in any event: a. Shall be prominently posted in the sales office; Shall be contained in a contract for the sale of a lot or dwelling unit, and if not printed in "red lettering" or similar highlighting, shall be specifi- cally pointed out to a prospective purchaser prior to execution of any such contract; c. Shall be printed in readily legible typeface on any map or plat used for marketing purposes. Exceptions: The disclosure required by this 'section need not be made: a. In advertising by signage, radio, television, news- paper, or multiple listing service; By a person presently owning and who has never owned within the subdivision or development more than the single un/t which is offered for sale. 6. Pre-approval of Modified Disclosure: An.v proposed modification of the language of the required disclosure shall be submitted to the City Attorney for approval, prior to use. The City Attorney shall approve any modification which is factually accurate and serves to inform a prospective purchaser at least as well as the language set forth above. SECTION 29-36 FINAL.01ECORD) PLAT 29-36.1 Final Plat Submittal Requirements Final Plat Information Requirements: The final plat shall be drawn at any scale, from one inch equals twenty feet (1" = 20') to one inch equals one-hundred feet (1" = 100') in any increments often (10) feet, on one or more sheets not less than eight and one-half inches by fourteen inches (8-1/2" x 14") or greater than thirty-six inches by forty-two inches (36" x 42") in size, including a north arrow, scale, date, and revision date block. The original of the final plat shall be drawn or photographically reproduced on mylar drafting film. Pen or laser plots on mylar film may be accepted so long as the image is permanent. All dragring on, and revisions to, any original shall be clearly legible so that the drawings are suitable for microfilming or digital scanning. The plat shall contain all the information required in a preliminary plat, but in its final form, subject to the following qualifications and additional information require- ments: All dimensions and bearings, both linear and angular, radii and arcs, necessary for locating the boundaries of the subdivision, blocks, lots, streets, alleys, easements, and any other areas for public or private use. The error of enclosure of the subdivision boundary survey shall not exceed one in ten thousand (1 foot for each 10,000) feet of perimeter survey. The linear dimensions shall be expressed in feet and decimals of a foot. Accurate distances and directions to the nearest permanent survey monument from which the survey was made. c. Lecation an_d description of all survey monuments (see Section 29-51.11 of this Chapter). When lots are located on a curve or when side lot lines are at angles (from the street right-of-way) other than ninety (90) degrees, the width of lot at the front building setback line shall be shown. chapt29.fin 4-12 x, approved by the Plan Commission on October 22, 1997